Troubleshooting - infaco PW3 Original User Manual

troubleshooting

Disruptions
The machine
will not start
Machine stops
when in use
The machine stays
on standby
18
Causes
Machine not powered
Fault D01
Battery discharged
Fault D02
Too heavy strain
Mechanical jam
Fault D14
Safety brake acti-
vated
Incorrect tool de-
tection
Other
Fault D01
Battery discharged
Fault D02
Too heavy strain
Fault D14
Safety brake acti-
vated
Other
Overheating
Incorrect tool de-
tection
Solutions
Reconnect it
Recharge the battery.
Restart by pressing the trigger
once.
If the problem persists, contact
your dealer.
With the chain saw, check that
the chain brake handle is present
and check that the chain brake is
released.
Disconnect for 5 seconds, then
reconnect.
Check the tool assembly.
If the problem persists, contact
your dealer.
Contact your dealer.
Recharge the battery.
Change the work method or ask
your dealer for advice.
Restart by pressing the trigger
once.
Unlock the brake.
Check the tool assembly.
As soon as the green indicator
comes back on, restart by pressing
the trigger twice.
Contact your dealer.
Wait for the machine to cool and
restart using two presses on the
trigger.
Disconnect for 5 seconds, then
reconnect. Check the tool assem-
bly. If the problem persists, contact
your dealer.