Troubleshooting; Technical Specifications - Panasonic RX-ED50 Operating Instructions Manual

Troubleshooting

Before requesting service, make the below checks. If you can't fix the system as described below, or if something not listed
here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.
Reference pages are shown as black circled numbers
Common problems
"E" is displayed
"UO1" is displayed
"UO2" is displayed
CD
CD won't play or CD display is incorrect
Cassette deck
Recording not possible
Poor sound quality
Radio
A lot of noise or difficult to tune
Remote control
The remote control doesn't work.
The unit can't be turned on from the remote
control.

Technical specifications

Radio
Frequency range
FM 87.50–108.00 MHz (50 kHz steps)
AM
CD player
Sampling frequency
Decoding
Beam source Semiconductor laser (wavelength 780 nm)
No. of channels
Wow and flutter
D/A converter
Tape recorder
Track system
Monitor system
Recording system
Erasing system
Frequency range
Normal position
High position
Matsushita Electric Industrial Co., Ltd.
Osaka 542-8588, Japan
Indicates incorrect operation. Read the instructions.
Replace the batteries or use household AC power.
Batteries haven't been inserted. Insert batteries or use household AC
power. ("UO2" appears only if you have inserted memory batteries.)
Clean the CD
Wait for about an hour for condensation to clear and try again.
Make sure the label is facing up.
Replace the CD if it is scratched, warped, or irregularly shaped.
Have the cassette's tabs been removed? Cover the holes with tape.
Clean the heads.
Interference may be caused by other equipment. Turn the other equipment
off or separate this unit from them.
Interference may occur if a remote control from other equipment is used.
Check the batteries are inserted correctly.
Replace the batteries if they are worn.
Use the power button on the main unit if you are using batteries to power
the unit.
522–1629 kHz (9 kHz steps)
44.1 kHz
16 bit linear
2 channel, stereo
Below measurable limit
MASH (1 bit DAC)
4 track, 2 channel, stereo
Variable sound monitor
AC bias
AC erase
30 Hz–16 kHz
30 Hz–17 kHz
.
General
Speakers
Full Range
Jacks
Output PHONES: 3.5 mm stereo (16-64
Input
Power requirement
AC
Battery
Memory back-up for computer/clock
Dimensions (W H D)
X X
Weight
Specifications are subject to change without notice.
Weight and dimensions are approximate.
8 cm 6.0
AUX IN: 3.5 mm stereo
230–240 V, 50 Hz
Power consumption: 30 W
12 V (Eight R20, D, UM-1 batteries)
6V (Four R6, AA,UM-3 batteries)
490 142 291 mm
About 5 kg
without batteries
RQT5142-B
M1099X0
2
X
)
En