Advertisement
Available languages
Available languages
Trouble or fault
The control switch cannot be
pressed, or is stuck.
Product or battery gets very
hot
LEDs of the battery show
nothing
SF 6H-22
Hammer-action drilling is not
possible.
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
Further information
For more information on operation,
qr.hilti.com/manual/?id=2275218
This link is also to be found at the end of the documentation, in the form of a QR code.
Mode d'emploi original
1
Indications relatives à la documentation
1.1
À propos de cette documentation
•
Lire intégralement la présente documentation avant la mise en service. C'est la condition préalablement
requise pour assurer la sécurité du travail et un maniement sans perturbations.
•
Bien respecter les consignes de sécurité et les avertissements de la présente documentation ainsi que
celles figurant sur le produit.
•
Toujours conserver le mode d'emploi à proximité du produit et uniquement le transmettre à des tiers
avec ce mode d'emploi.
12
Français
Possible cause
The forward/reverse switch is in
the middle position (transport posi-
tion).
Electrical fault
Battery defective
The operating mode is not set cor-
rectly at the selector ring.
technology,
environment and recycling,
Action to be taken
▶ Set the forward/reverse switch
to forward or reverse rotation,
as applicable. → page 10
▶ Switch the product off immedi-
ately and remove the battery.
Allow it to cool down while
keeping it under observation.
Contact Hilti Service.
▶ Contact Hilti Service.
▶ Set the selector ring to the
"Hammer-action drilling" posi-
tion
.
follow this link:
2275218
*2275218*
Advertisement
