EIBENSTOCK ESD 162 Original Instructions Manual page 18

During use, the user and other persons standing nearby have to wear

suitable goggles, helmets, ear protectors, dust mask, protective cloves
and boots.
The tool may be used only in two-hand operation or with the drill

rig. During manual operation, always hold the tool with both hands
and be fall-safe. Consider the tool's reaction torque in case of
blocking.
Always work in a carefully considered way and do not use the tool

if you are lacking consideration.
Hold power tool by insulated gripping surfaces, when performing

an operation where the cutting accessory may contact hidden
wiring or its own cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and could give the
operator an electric shock.
During manual operation, work with a special circumspection

when dry drilling with dimensions between 102 and 132mm!
For further safety instructions, see the enclosure.
Electrical Connection
The ESD 162 is made in protection class 1.
Prior to putting the tool into operation, check the mains voltage for
conformity with the requirements of the tool's nameplate.
Voltage variations between + 6 % and – 10 % are permissible.
Use only extension cable with sufficient cross-section (min. 2,5 mm
cross-section which is to small could lead to excessive power loss and to
overheating the motor and the cable.
Recommended minimum cross sections and maximum cable lengths
Mains voltage
110V
230V
The tool includes a start-up speed limiter to prevent fast expulsion fuses
from unindented responding.
Cross section in sq. mm
1.5
20 m
50 m
17
). A
2
2.5
40 m
80 m