Getting Started; Router Setup - Asus 4G-AX56 User Manual

2 2

Getting started

Getting started

2.1 Router setup

IMPORTANT!
• Use a wired connection when setting up your wireless router to
avoid possible setup problems.
• Pinning down the location of your nearest cell tower will help you
find the strongest signal.
The default username and password for Web GUI are admin and
•
admin.
NOTES:
• Ensure that the Mobile Broadband LED lights up before configuring
4G-AX56 with Mobile Broadband. Turn off the 4G-AX56 and check
the fitting of your Nano SIM card if otherwise.
• 4G-AX56 can be configured to accept either Mobile Broadband or
Ethernet WAN source. Load Balance and Fail Over is also supported
between the two sources if both sources are available.
• 4G-AX56 automatically detects the ISP connection type at default
state. During the QIS (Quick Internet Setup) process, you may be
asked to key in the PIN code of the Nano SIM card installed and the
APN (Access Point Name) information of the mobile carrier in order
to receive connection.
1. Insert a Nano SIM card into 4G-AX56.
2. Plug the power adapter into the DCIN port and switch ON
4G-AX56. Wait for a couple of minutes for 4G-AX56 to become
ready.
3. Connect to 4G-AX56 via either wired or wireless connection.
[Wired Connection]
•
Connect an Ethernet cable between your computer
and any of the yellow Ethernet ports at the back of
4G-AX56.
11