Exhaust Air Pipeline; Guaranty - Respekta CH 11050 ISB User Manual

English
according to its mounting instructions and refit the
grease filter(s).
The carbon filter(s) is / are mounted at delivery
in the case of only-circulating hoods.
11.6 Mounting the extractor hood
See chapter "installation instructions"
applicable the separately supplied mounting
instructions.

12. Exhaust air pipeline

(Required for exhaust mode only)
Exhaust line and their installation accessories are
not included.
Ideally, the electrical connection cable is routed
through a false ceiling.
Ideal exhaust line according to the figure here
below.
 The exhaust air line should be as short and
straight as possible.
 To avoid excessive noise or a reduced extraction
capacity the diameter of the exhaust air pipeline
should not be less than 120mm.
 Use or form only large radius bends. Small radius
bends reduce the extraction capacity of the hood.
 Use only smooth pipelines or flexible hoses of
non-flammable materials for the exhaust air
pipeline
fi200512
Operating instructions / users manual Cooker Hoods
or where
 If the exhaust air pipeline is horizontally routed,
there must be a minimum gradient of 1 cm per
meter or an inclination angle of min. 1°.
Otherwise condensation water could run into the
extractor hood motor.
 If the exhaust air is directed into an exhaust air
duct, the end of the entry fitting must be directed
in the direction of flow.
 If the exhaust air pipeline is routed though cool
rooms, lofts etc. there can be a large temperature
drop within the individual parts of the pipeline,
resulting in sweating or condensation water
production. This renders outlet pipeline insulation
necessary.
 In some cases a condensation water backflow trap
must be installed in addition to adequate insulation
(these are available from leading building material
suppliers).

13. Guaranty

Please take note of the general Guaranty terms and
the Guaranty period, stated in the attached Guaranty
card.
If the appliance documentation does not include a
Guaranty card, please contact your dealer.
There is no Guaranty on light fittings.
The manufacturer is not responsible for any
faults occurring through non-compliance with the
above information and provisions.
The manufacturer is constantly engaged in the
further improvement of his products. Please note
that products are subject to changes in form,
equipment and the applied technology.
8
GB