Siemens EX LY Series User Manual page 18

en Wireless cooking sensor
​ ⁠ Template
¡
16.2 Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. For fitting on the cookware:
1. Clean and dry the cookware thoroughly. Ensure that
there are no grease residues in the adhesive area.
2. Remove the protective film from the silicone patch.
Adhere the silicone patch to the outside of the cook-
ware in the correct place using the enclosed tem-
plate as a guide.
3.
Press down all over the surface of the silicone
patch, including in the centre.
4. Leave the adhesive to dry for one hour. Do not use
or rinse out the cookware during this time.
Note: If the silicone patch comes loose, use a new
one. If required, you can purchase a set with five silic-
one patches from specialist retailers, from our cus-
tomer service or on our official website www.siemens-
home.bsh-group.com by quoting the article number
17007119.
All adhesives break down over time when they are
stored. To prevent this from happening, place the silic-
one bases on their containers as soon as they are
cleaned.
16.3 Attaching the wireless cooking sensor
1. Ensure that the silicone patch is completely dry be-
fore attaching the cooking sensor.
2. Attach the cooking onto the silicone patch so that it
fits perfectly.
18
16.4 Replacing the battery
If the LED on the wireless cooking sensor does not
light up when pressed, the battery is discharged. Chan-
ging the battery:
1. Remove the silicone cover from the lower section of
the cooking sensor casing and remove both screws
using a screwdriver.
2.
Open the cooking sensor lid and remove the battery
from the base.
!