Flair 58x Quick Start Manual

What's Included in Your Flair 58x
1)
What's Included:
1) Lever 8) Brew Base
2) Lever Assembly 9) 58mm Portafilter
10) Base
3) Pressure Gauge
4) Plunger Stem 11) Drip Tray
5) Lever Hook 12) Tamper
13) Kettle Preheat Cap
6) Valve Plunger
14) Puck Screen
(in Brew Cylinder)
7) Brew Cylinder
3)
2)
5)
6) 12)
4)
7)
13)
8)
9)
14)
11)
10)
Flair 58x Quick Setup Instructions
Watch our full online tutorials via the QR Code!
1 2 2
Bolt base & lever Remove preheat cap & install brew
assembly together cylinder onto brew base. Rotate
firmly counterclockwise to lock
3
4
(a)
(b)
Align (a) plunger Lower lever hook and
stem tabs to slots on connect to plunger
valve plunger. Rotate stem
(b) stem to lock.
Gauge will face front
Filling Your Flair 58x with the Valve Plunger
Filling Your Flair 58x with the Valve Plunger
(a) Fill brew cylinder to rim with water (b) Raise lever enough to
unseat stem and open valve allowing water to fill head space below
(c) Continue to raise lever slowly, and water will pass through the
valve and into the brewing chamber (d) Top-off chamber through
opening made between stem and plunger once lever is fully raised
(b)
(a)
(d)
(c)
Preheating Your Flair 58x
(a) Raise lever & unlock and lift lever hook (b) Remove the brew
head by turning clockwise with gauge in place (c) Add Open Preheat
Cap onto bottom of brew head (d) Lift kettle top and replace with
brewhead (e) Turn plunger stem counterclockwise until two tabs
align with openings in plunger, leave in place to act as a release valve
(f) Boil water to preheat
(c)
(a)
(b)
(d) (e) (f)
*NOTE: If the brew head does not fit on your kettle, preheat
your chamber with boiled water and the valve plunger
lowered. Purge and repeat as necessary.