Advertisement
Parts Definition/ Installation/ Mounting Hole Specifications
■ Parts Definition/ Installation
Cover (ABS)
Lens(AS)
Housing(ABS)
Rubber spacer
Flange nut
• First, machine holes on the mounting surface.
• The mounting hole of this product is 4.5mm in diameter.
• When machining taps, fasten the bolt through the mounting hole of
the bracket.
• When machining holes, insert the bolt through the hole of the product,
and tighten the nut from the opposite side of the mounting surface.
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP23.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated, it may cause malfunction or damage to the product.
• For further information, please visit our website (www.qlight.com).
Mounting Accessories (Sold Separately)
• Please refer to the dimensions below for installation of mounting brackets
PCD30~40
ST56MEL-BZ-3-24-
RAG-JC
360°/3-
Ø5 HOLES
4-Ø5 HOLES
Ø12 CABLE ENTRY
Ø12
Ø12
Ø12
PCD30~40
360°/3-
Ø5 HOLES
4-Ø5 HOLES
Ø12 CABLE ENTRY
TWS45
Ø12
■ Mounting Hole Specifications
•
Machine holes on the mounting surface referring to the
diagram below.
3-Ø4.5 HOLES
Min.Ø5 CABLE ENTRY
PCD 40
Dimensions
PCD30~40
360°/3-
Ø5 HOLES
4-Ø5 HOLES
3
PCD40~50
PCD40~50
PCD30~40
360°/3-
Ø5 HOLES
4-Ø5 HOLES
TWA45
Advertisement
