Panasonic BB-HCM331A Operating Instructions Manual page 80

Operating Instructions
Setting
Display
IP Address
Host Name
Port No.
Camera Name
*1 In IPv4, set 4 digits (0—255) and 3 periods such as "192.168.0.253". But
"0.0.0.0" and "255.255.255.255" are not available.
In IPv6, set the host name.
Enter ASCII characters for the host name (see page 140). But [Space], ["], ['],
*2
[#], [&], [%], [=], [+], [?], [<] and [>] are not available.
Enter 1—255 characters.
Enter ASCII characters (see page 140) or characters in each language (1—15
*3
characters for a 1-byte character and 1—7 characters for a 2-byte character).
But [Space], ["], ['], [#], [&], [%], [=], [+], [?], [:], [<], and [>] are not available.
Notes
• Set the local IP address and port number for the camera on the same
LAN.
• If the cameras will be accessed from the Internet, be sure to use the global
IP address. In this situation, local IP addresses such as 192.168. x.x
cannot be used.
4.
Click [Save] when finished.
• New settings are saved.
• The Multi-Camera Setup page is displayed.
80
• Check the box to enable the camera.
or • Set the IP address or the host name to enable the camera.
*1
*2
• Set the port number (1—65535).
• This camera name is displayed only on the Multi-Camera
*3
page.
Description