Table of Contents
Advertisement
4. Installation
NOTE: Before installation, please inspect the unit. Be sure that nothing inside the
package is damaged.
4.1 Mounting the unit
The unit ONLY can be mounted vertically
to a wall surface.
Please follow below steps:
1. Turn off the unit before mounting,
2. Select an appropriate mounting location.
Use a horizontal line and the length of the
line must be 172 mm and mark the two
ends on the wall.(See Fig. 1)
3. Drill two marks by screws.
4. Mount the unit by positioning the
key-hole slots over the mounting screws.
4.2 Connect to Utility and Charge
Plug in the AC input cord to the wall outlet. The unit will automatically charge the
connected external battery even though the unit is off.
Connect External Battery
Step 1- Take away the cover of external battery terminal.
Step 2- Following battery polarity guide printed near the battery terminal!
Place the external battery cable ring terminal over the battery terminal,
RED cable to the positive terminal (+);
BLACK cable to the negative terminal (-).
Step 3- Connect battery cables to the external batteries.
Note: For the user operation safety, we strongly recommend that you should use tapes
to isolate the battery terminals before you start to operate the unit.
1) Single battery connection (Refer to Fig. 2): When using a single battery, its voltage
must be equal to the Nominal DC Voltage of the unit (see below Table 1)
SCC SKY INVERTER User Manual
Fig. 2
Model
SCC SKY
INVERTER 1000
SCC SKY
INVERTER 2000
3
Fig. 1
Nominal Battery
Voltage
12Vdc
24Vdc
Advertisement
Table of Contents
