Composite Input Connection - Crown FM5 User Manual

2.7 Composite Input Connection

You may feed composite stereo (or mono audio) directly to the RF exciter bypassing the
internal audio processor and stereo generator. To use the Crown transmitter with composite
input, it is necessary to use the Composite Input section of the transmitter. This will feed
composite stereo (or mono audio) directly to the RF exciter and will bypass the internal ste-
reo generator.
Input sensitivity is approximately 3.5–volt P-P for 75 kHz deviation.
1. Enable the Composite Input by adding a jumper across the pads of JP2
(see Illustration 2–12).
2. Connect the composite signal using the "Composite In" BNC connector.
RF Out
2-6
Illustration 2–12 Jumper JP2
Composite In
Illustration 2–13 Composite In Connection
FM5 User's Manual