Download Print this page
Safe Fleet TH8 Quick Installation Manual

Safe Fleet TH8 Quick Installation Manual

12 v poe injector

Advertisement

Quick Links

Warranty
For full warranty information, visit:
www.seon.com/documents/Seon-Warranty.pdf
2002/96/EC (WEEE directive): This product cannot be disposed of as unsorted municipal waste
in the European Union. For proper recycling, return the product to your local supplier upon the
purchase of equivalent new equipment, or dispose of it at designated collection points, for more
information, see www.recyclethis.info.
2006/66/EC (battery directive): This product does not contain batteries.
Support
Phone: 1.844.899.7366
Email: PTsupport@safefleet.net
TH8 & NH16 12 V POE Injector Quick Installation Guide
About
This guide covers the installation procedures for connecting a 12 V POE (Power Over Ethernet) injector kit to
TH8, NH16K, and NH16 recorders.
A POE injector kit enables connection of up to
ports. NH16 recorders can power a Smart-Reach WiFi bridge. TH8 and NH16K recorders can also power
compatible IP cameras.
Pre-requisites
Before proceeding with this document, you must first have a TH8, NH16K, or NH16 recorder installed and
functioning in a vehicle, The recorder must meet the following minimum firmware requirements:
TH8/NH16K recorder - FW 2.x or higher
NH16 recorder - FW 3.x or higher
Do not proceed with this document if you haven't installed the recorder. Installation Guides are available on the
Safe Fleet Community (https://community.safefleet.net).
Note: You will need login credentials to access the documentation. Please contact Technical Support if you do
not have access to the Community.
Kit Contents
(1 kit required per device added)
12 V POE Injector Kit (Part #: NVRPOEKIT12):
POE Injector Harness (Part #: APPINJ) - Qty 1
Y-Power Harness (Part #: 060-1163) - Qty 1
Specifications
12 V POE Injector Adapter Harness
Materials
Voltage Rating
RJ45 Jack
RJ45 Power Pins
DC Wire Size
CAT5 Wire Size
Cable Length
Total Length
Weight
Operating Temp
2 additional 12 V devices
to the recorder's rear-panel Ethernet
UL Rated Materials, Meets RoHS Requirements
60VDC Maximum
Shielded CAT5 Rated, Gold Plated Contacts
4, 5 (+) 7, 8 (-)
28AWG x 4
24AWG x 8, Shielded
165mm (6.5")
254mm (10")
31 g (1.1 oz )
-40°C to 80°C (-40°F to 176°F)
© Safe Fleet | 2020 | All rights reserved | Part #: 700-1219 R1

Advertisement

loading

Summary of Contents for Safe Fleet TH8

  • Page 1 NH16 recorders can power a Smart-Reach WiFi bridge. TH8 and NH16K recorders can also power compatible IP cameras. Pre-requisites Before proceeding with this document, you must first have a TH8, NH16K, or NH16 recorder installed and functioning in a vehicle, The recorder must meet the following minimum firmware requirements: •...
  • Page 2 Safe Fleet Community, or contact Technical Support.  NOTE: Configuring CHW8 for the Recorder This procedure is covered on pages 2-3 of document #700-1200 (CHW8 Quick Setup Guide for TH8 4. Plug the POE Injector Power Harness’ Ethernet Connector into the recorder’s rear-panel POE WIFI port,...

This manual is also suitable for:

Nh16