Advertisement
Glue the motor mount stick onto the ceiling. Use Epoxy. Add the two "wing
supports".
Prepare wing and tail parts. The elevator halves are cut out with a soldering
iron. Again don't cut all the way through! Leave a bit depron for the hinge.
The elevator halves are joined with a piece of balsa.
The rudder is full-flying, so just bevel the edge that is attached to the
fuselage.
The wing halves are bent to an airfoil shape and are glued together with
contact glue. Reinforce the bond with clear tape. The ailerons are optional!
Advertisement
