Kidde Fire Systems Argonite Design, Installation & Maintenance Instruction page 5

This manual is written for those who are designing, installing or providing maintenance to a Kidde Fire Systems
Argonite Engineered Fire Suppression System.
®
Kidde-Fenwal assumes no responsibility for the application of any systems other than those addressed in this manual.
The technical data contained herein is limited strictly for information purposes only. Kidde-Fenwal believes this data
to be accurate, but it is published and presented without any guarantee or warranty whatsoever. Kidde-Fenwal
disclaims any liability for any use that may be made of the data and information contained herein by any and all other
parties.
Kidde Argonite Fire Suppression Systems are to be designed, installed, inspected, maintained, tested and recharged
by qualified, trained personnel in accordance with the following:
• Standard of the National Fire Protection Association No. 2001, titled Clean Agent Fire Extinguishing Systems.
• All instructions, limitations, etc. contained in this manual, P/N 38-KFSARG-000.
• All information contained on the system container nameplate(s).
Storage, handling, transportation, service, maintenance, recharge, and test of agent storage containers shall be
performed only by qualified and trained personnel in accordance with the information in this manual and Compressed
Gas Association pamphlets C-1, C-6 and P-1:
• C-1, Methods for Hydrostatic Testing of Compressed Gas Cylinders.
• C-6, Standards for Visual Inspection of Compressed Gas Cylinders.
• P-1, Safe Handling of Compressed Gases In Containers.
CGA pamphlets are published by the Compressed Gas Association, Crystal Square Two, 1725 Jefferson Davis High-
way, Arlington, VA 22202-4102.
Any questions concerning the information presented in this manual should be addressed to:
Kidde-Fenwal Inc.
400 Main Street
Ashland, MA 01721
Phone: (508) 881-2000
Fax: (508) 881-8920
September 2004
FOREWORD
i
®
38-KFSARG-000