¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
WARNING ‒ Risk of injury!
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
16.3 Electrical connection
In order to safely connect the appliance electrically, fol-
low these instructions.
WARNING ‒ Risk of electric shock!
Incorrect installation is dangerous.
Only a qualified electrician may route the socket or
▶
replace a power cable while taking into considera-
tion the applicable regulations.
Connect the appliance only to a correctly installed,
▶
earthed socket.
If the plug is no longer accessible following installa-
▶
tion, an all-pole isolating unit with a contact clear-
ance of at least 3 mm must be available on the in-
stallation side. Contact protection must be ensured
by the installation.
16.4 Installation in a wall unit
Observe the installation dimensions and the safety
clearances in an upper cabinet.
Only install 20 l appliances in a wall unit.
16.5 Installing in a tall cupboard
Observe the installation dimensions and the safety
clearances in a tall unit.
16.6 Preparing the 20 l appliance
For a cabinet niche of 380
1.
the feet to the bottom of the microwave.
Secure the spacer to the mounting bracket.
‒
Route the connecting cable along the back of the
2.
appliance so that it does not become hot, kinked or
trapped.
Installation instructions en
+2
mm in height, secure
21