Onkyo CR-B8 Instruction Manual page 19

CRB8.book 19 ページ ２００５年８月１８日 木曜日 午後６時４０分
Connecting an RI Dock (Remote Interactive Dock)
The following diagram illustrates how to connect the Onkyo Remote Interactive Dock (RI Dock).
Connect the HDD IN jacks on the CD receiver to the AUDIO OUT jacks on the RI Dock.
CD receiver's
rear panel
: Signal flow
The jack connection enables you to use the following functions:
• You can control a connected Onkyo RI Dock using the supplied remote controller. You also need to connect the analog
audio cable. Please refer to the instruction manual attached to the RI Dock for correct connection. If the HDD device
has a MODE switch, you must set the switch to HDD.
• When the connected Onkyo RI Dock plays back, the input selector on the CD receiver is automatically switched to
HDD.
• If the source name assigned to HDD jacks is CD-R, it should be reset to HDD (default setting).
Please follow the steps on page 20 to change the source name in the display. Select HDD for the input source in Step 4.
• If a component has two
used to daisy chain with another component.
Connecting External Devices —Continued
Analog audio cable (RCA)
red
white
An cable that comes with
the compact disc recorder
terminals, you can use either one to connect to the CD receiver. The other one can be
white
red
S VIDEO OUT AUDIO OUT
Jacks on the RI Dock's rear
panel
DC IN
19