Instructions For Using E-Stop System - Pro Audio Trade BEAM BOX 5W Manual

on the combining optics until all the beams overlay each other perfectly.
!
Take extra care to avoid interrupting the laser beam with any tools. Class 4 laser
reflections could result.
7. Once the alignment is satisfactory then power down the system.
8. Replace the top panel and replace the hex button bolts.

11 INSTRUCTIONS FOR USING E-STOP SYSTEM

The E-STOP BOX is used to switch off any connected effect lasers directly in the event of a hazard.
Once there is an emergency issue, laser can be shut down immediately by pushing the mushroom
switch, or turn off the KEY switch on the E-STOP BOX.
Connect the E-STOP BOX to the 3-pin interlock connector on the rear of the laser projector using a
3-pin XLR cable.
NO. Name
1
Laser emission LED
2 START
3 Key switch
2
Function
After pressing START button, this LED will keep flashing. It takes
about 10 seconds for activating laser output. The LED indicator will
stay steady ON as soon as the laser beam is emitted.
VERY IMPORTANT! Every time the laser is shut down, it will be
required to press this START button again, to restart laser emitted.
Key switch for laser on and off.
1
3
4
17