Connecting External Memory; Network Connection; Navigating Menus; Installation - Labgear LCOM1 User Manual

Connecting external memory

The receiver supports all types of hard disk drives and USB flash drives. See the "Advice on Recording USB Media"
on page 2. Connection can be made via either of the USB ports on the back or the side of the receiver.
Connected drives can be used for recording satellite and TV programmes and for playback of these recordings
as well as playback of a wide range of video, music and image files stored on USB media,

Network connection

The RJ45 port allows you to connect the receiver to a local network using a patch lead connected to a router.
Alternatively network connections can be made using a USB Wi-Fi dongle.

Navigating menus

Some keys on the remote allow direct access to functions of the receiver. Such as MENU and OK. Some keys are
multi-functional and their operation depends on the type of device selected by the user. See below some of the
device functions available through the user menu.
1. The / up/down arrow keys on remote move the cursor up and down the menu.
2. The / left/right arrow keys on the remote are move the cursor left and right, or to go to submenus.
3. The OK key is used to enter submenus.
4. The EXIT key is used to exit menus or functions.
5. In a submenu, press the OK key to confirm a selection; a green background indicates an active function.
Main menu
Press the MENU key display
the main menu and access
the following menus:

1. Installation

2. Channel List
3. System
4. Media Centre
5. YouTube
Installation
This menu sets satellite/terrestrial/
cable search parameters and to
search channels for them.
Satellite list
This menu sets satellite/terrestrial/
cable search parameters and
allows you to search for channels.
Satellite
Use the / keys to move up and
down the list and press OK to select
a satellite(s). Selected satellites will
be marked with a tick. If you have
a standard static satellite dish it will
usually just be a single satellite.
1. Then press the blue key to scan.
If one satellite is marked for scan,
it will be a single satellite search,
if multiple satellites are marked, it
will be a multi satellite search.
2. Press green key to edit a satellite
3. Press yellow key to delete a satellite.
4. Press the red key to add a satellite
not listed.
6