Table of Contents
Advertisement
Installing the Hydraulic
System
1.
Unpack the hose guide, hydraulic return hose
(hose #3), hydraulic suction hose (hose #4), 4
bolts (1/4 x 3/4 inch) and 4 locknuts (1/4 inch).
Note:
Remove the hose secured to the hose
guide, hydraulic return hose and hydraulic
suction hose for shipping.
2.
Using 2 bolts (1/4 x 3/4 inch) and flange
locknuts, attach the hose guide to the bracket
on the hydraulic tank
1. Hose guide
Note:
Remove the 2 mounting bolts must from
the chassis rear wall. Use the removed bolts
to mount the tank.
3.
Unpack 4 bolts (3/8 x 1 inch) and nylon locknuts.
Supporting the hydraulic tank from below, pass
the hose guide and hydraulic hoses #3 and #4
through the large central hole in the chassis rear
wall and locate the hydraulic tank against the
chassis rear wall. Temporarily clamp, or bolt, the
hydraulic tank in place.
Note:
The hose guide should be fed through
the center hole on the front side of the chassis.
2 people may be required.
4.
Install the hydraulic return hose (#3) and the
hydraulic suction hose (#4) to the appropriate
fittings on the hydraulic tank.
Note:
Hose #3 and hose #4 do not have the
same fittings; each hose will fit only into the
correct fitting in the hydraulic tank.
Note:
When mounting the hoses, ensure that
there is adequate clearance for the tires.
(Figure
9).
Figure 9
5.
The hose guide should sit on top of the tab from
the vertical leg of the battery tray
If the holes in the hose guide do not match the
holes in the battery tray tab, the hose guide
length may be adjusted by loosening the bolts
attaching the hose guide to the hydraulic tank
bracket and sliding the hose guide forward or
to the rear as required.
1. Hose guide
6.
Attach the hose guide to the battery tray tab
using 2 bolts (1/4 x 3/4 inch) and flange locknuts
g013863
(Figure
10).
7.
Mount the hydraulic tank to the chassis rear
wall using the previously removed mounting
bolts, as well as the bolts (3/8 x 1 inch), nylon
locknuts, and flat washers from the kit, Tighten
the fasteners.
8.
Connect hydraulic hose #3 to the filter outlet
(Figure
11).
1. Filter outlet
7
(Figure
Figure 10
Figure 11
2. Hydraulic hose #3
10).
g013864
g013865
Advertisement
Table of Contents
