Operation; Servicing The Engine Oil - Toro 44713 Installation Instructions Manual

Propass 200 top dresser with tow-type chassis
Hide thumbs Also See for 44713:
Table of Contents

Advertisement

4.
Fill the engine with approximately 1 L (34 fl oz)
of the proper viscosity oil before starting; refer to
Servicing the Engine Oil (page
Important:
The engine is shipped from the
factory without oil; attempting to start the
machine before you fill it with oil will cause
engine damage.
5.
Check the level of oil before the engine is first
started; refer to
Servicing the Engine Oil (page
10).
6.
Fill the hydraulic tank with the proper hydraulic
fluid; refer to
Servicing the Hydraulic System
(page
11).
Important:
The hydraulic system will not
completely fill with fluid until the system is
powered up. Check the hydraulic fluid level
and add fluid as necessary to ensure that it is
at the correct level after using the hydraulic
system for the first time.

Operation

10).
Ensure that all control systems are turned off
when working on the power pack.

Servicing the Engine Oil

Important:
Refer to the engine owner's manual for additional
information.
The engine is shipped from the factory without oil; it
must be filled with approximately 1 L (34 fl oz) of oil
before starting.
Check the level of oil before the engine is first started
and daily thereafter.
The engine uses any high-quality oil having the
American Petroleum Institute - APl - "service
classification" SJ, SL or equivalent. Oil viscosity
- weight - must be selected according to
ambient temperature.
temperature/viscosity recommendations.
1.
2.
3.
4.
5.
6.
7.
10
CAUTION
The engine is shipped without oil.
Figure 20
Figure 20
Position the machine so that the engine is level.
Clean the area around the oil filler cap/dipstick.
Remove the oil filler cap/dipstick by rotating it
counterclockwise.
Wipe the dipstick clean and insert it into the filler
port. Do not screw it into the port.
Remove the dipstick and check the level of the
oil.
If the level is near or below the lower limit mark
on the dipstick, add only enough oil to raise level
to the upper limit mark.
Important:
Do not overfill the crankcase.
Check the engine oil level again.
illustrates the
g018667

Advertisement

Table of Contents
loading

Table of Contents