Breville VCF152X Instructions For Use Manual page 27

Barista max+ espresso machine with intelligent grind & dosage
Table of Contents

Advertisement

Available languages

Available languages

CARE & CLEANING - ESPRESSO MACHINE
Cleaning Cycle
The CLEAN LIGHT will illuminate blue to
indicate a Cleaning Cycle is required.
The Cleaning Cycle takes approximately 7
minutes to complete.
Preparing for Cleaning Cycle
- Ensure there is at least 1 Litre of water
in the Reservoir.
- Empty the Drip Tray & replace.
MAX
2.8L
1L
MIN
- The machine is on and in the READY
state.
- Place the Two Cup Filter Basket & the
Cleaning Disc into the Group Handle.
- Place one Cleaning Tablet in the
middle of the Cleaning Disc in the
space provided.
- Insert Group Handle into the Group
Head.
Start the Cleaning Cycle
- Simultaneously press & hold the ON/
OFF & MANUAL SHOT BUTTONS for
4 seconds. The machine will beep and
the Cleaning Cycle will start.
VCF152X_VCF153X_21MLM1 (EMEA).indd 27
VCF152X_VCF153X_21MLM1 (EMEA).indd 27
Note: The Cleaning Cycle can be exited
at any point by pressing the ON/OFF
BUTTON.
- The ON/OFF & CLEAN LIGHTS will
flash during the cleaning cycle.
- Water will purge into the Drip Tray and
small amounts of water will pour from
the Group Handle spouts.
Cleaning Cycle Complete
- The machine will beep and the ON/
OFF & CLEAN LIGHTS will stop
fl ashing.
- The machine will return to the READY
state.
- Remove the Group Handle from the
Group Head. Check tablet has been
dissolved.
Note: If the tablet has not been dissolved,
insert the Group Handle back into the
Group Head, empty the Drip Tray &
replace. Repeat the 'Start the Cleaning
Cycle' section.
Cleaning Cycle Clean Up
- Purge the Group Head by pressing the
ONE CUP BUTTON and water should
fl ow.
- Allow water to run through until it
stops.
- Wash the Drip Tray, Group Handle &
Cleaning Disc in warm water with a
mild detergent, rinse & dry.
Group Head Silicone Seal
A Silicone Seal is located in the Group
Head and creates a seal against the Filter
Basket when making an espresso.
Important: When not being used, we
recommend not to leave the Group Handle
inserted into the Group Head, as this will
reduce the life of the Silicone Seal.
Over time this Seal loses its elasticity and
may require replacement. The seal may
need replacing when watery espresso
leaks from around the Group Handle during
extraction, or if the Group Handle is loose
when fully turned to the centre position.
Note: Contact Breville should you think
that the Group Head Seal needs replacing.
Do not attempt to change the Silicone Seal
without first consulting Breville.
27
5/14/21 15:52
5/14/21 15:52

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vcf153x

Table of Contents