3.
Hold the hard disk drive by the locking handle (1), then insert
the handle locating lugs (2) and four locating feet (3) into the
holes in the main board making sure the hard disk connector
(4) starts to engage with the socket on the control board.
4. Gently push down on the locking handle (1) making sure the
hard disk moves forward and fully engages with the socket.
5. Replace the main board and secure it with the two screws.
6. Connect the printer interface cable and power cable, then
switch on the printer.
7. Print a MenuMap (see "Printing the MenuMap" on page 38)
and check that the HDD appears at the top of the MenuMap. If
it doesn't, pull the main board back out and reseat the HDD.
The printer will automatically configure to include this option.
However, you can also set the menu manually as follows:
1. Press the MENU button until
then press the SELECT button.
2. When
HDD INITIALIZE
hard disk install.eps
is displayed, press the SELECT button.
ES 3037/3037e Accessories • 224
DISK MAINTENANCE
is displayed,