Alberello Coolboy ICE 50 User Manual page 19

1. FUNCTIONS
- Principle of cooling: Water is taken from the water tank by the pump, after
reaching the top, the water drop and flow through the wetted pad (papare
evaporator), then the cooled/vaporised air is blown out whch result in a
cooling effect.
- Control panel: safe and user friendly.
- Adjustable speed: three speeds, blow at wide angle.
- Cooling: because of the water changing into vapor the air temperature is
becoming cooler and the relative humidity is raised.
- Cold wind at wide angle: The blades swing automatically blow the wind at a
wide angle. The vents automatically swing from left to right (oscillate). Also,
the blades can oscillate vertically by manual setting the angle.
- Remote control: Operates till 6 metres distance with a reception angle of up
to 60 degrees.
2. ASSEMBLING AND WATERING
1. Fit the castors with a wrench: turn the device around and lay on a flat surface
and fit the castors. Pay attention if castors with wheels are provided (pending on
your model): The rear wheel is with brake, but the front wheel is without brake.
2. Add water: Unlock the water tank at the back, pull the water tank for 1/3, fill the
tank with water, push the water tank back into the unit and lock the tank.
Pay attention:
A. During filling keep the fill level indicator closely watched.
b. The level of the water tank should never be filled more than "MAX" level
(do not overfill).
If the humidification function is used the water level in the tank must never be
below "MIN".
c. Put ice or a cooling element in the water tank for efficient cooling. But the total
filled level of the tank may never be more than "MAX".