Page 1
USE AND MAINTENANCE MANUAL STAINLESS STEEL ELECTRONIC DIGITAL CALIPER Art. C043/500, C043/1000, C047/500 TRANSLATION OF THE ORIGINAL INSTRUCTIONS...
MEASURING INSTRUMENTS Index INSTRUCTIONS ..................4 Operation ........................4 1.1.1 Operation keys ......................5 1.1.2 Data output....................... 5 Technical specifications ....................6 Applications ........................6 Battery replacement .....................6 Page 2 of 6...
Page 3
Manual on the date of issuance and listed herein; On the other hand, the machine may also be subject to important technical changes in the future, without the manual being updated. Therefore, see FERVI for information about modifications that could be implemented. REV. 2 February 2014...
MEASURING INSTRUMENTS 1. INSTRUCTIONS 1) Before using the caliper clean the surface of the protective adhesive using a clean, dry cloth. To remove condensation dirt, use a cloth lightly dampened with ethyl alcohol. 2) Conditions of use: Temperature 5 – 40°C Relative humidity: lower than 80% Prevent the protective adhesive from coming into contact with liquids containing water that can damage the circuit board.
MEASURING INSTRUMENTS 1.1.1 Operation keys ON/OFF: On and off switch IN/mm: Inch / mm conversion key. ABS/zero: Conversion key between absolute measurement / relative measurement. Absolute measurement: This is performed when the characters "INC" are not displayed on the screen. The closed measurement jaws, are usually taken as the starting point of the measurement.
MEASURING INSTRUMENTS 1.2 Technical specifications 1) Resolution: 0.01 mm 2) Repeatability: 0.01 mm 3) Accuracy: ±(0.02+0.00005 x L). ”L” is the length measured in millimetres. 4) Maximum speed of measurement: 1m/s 5) Power: SR44 cell battery, 1.55 V. 1.3 Applications 1) Keep the measuring surface of the caliper clean, and all the contact parts.