Advertisement
3.
INSTALL AND ASSEMBLY
3.1
ASSEMBLY
Ensure all local laws and codes including health and safety guidelines are met when installing this
!
Waterlogic purification system. Only qualified service technicians should attempt installation and
service. Always read the entire operating instructions before using the appliance and save these
instructions for future use.
1. Carefully unbox and remove the base cabinet parts from its packaging. Ensure there
are no trip hazards while you do this. Locate the down panel (Item 2, page 5) and the
rubber feet (Item 1, page 5). You will need to fit a rubber foot to each corner of the down
panel. Then locate the bottom hinge (item 3, page 5) and screw to the front, left hand
side of the down panel as per below image.
Note: If your ClassE unit came with caster wheels and they were installed on the unit, they
must be removed for the unit to seat properly onto the base cabinet. Those wheels may
be transferred to the base cabinet if desired for easier mobility. Removing and reinstalling
the caster wheels onto the base cabinet will require the use of a 14mm thin-profile
wrench pictured below.
Thin-Profile
Wrench – 14mm
7
Rubber Feet
Caster Wheels
Advertisement
