Advertisement
Setting 0 to 25V or (-25) to 0V:
First you want to look in the "Function" section and press the +25V key or -25 key
depending on which value you prefer. By doing this you are in 0-25 Volt or (-25)-0
output mode. You should see the resulting mode displayed. Next for safety purposes you
should press the Output On/Off button( so that the output is on) to make sure your output
is currently set to 0. You should now see Voltage with corresponding Current displayed.
You want to 0 the values out. You do this by using the left/right arrows to select each
digit you wish to change. You can change the digit by using the circular knob and turning
it clockwise to increase the value or turning it counterclockwise to decrease it. After this
is done push the Output On/Off button so that the output is off now.
If you wanted to use the output for 0-25 Volts you would simply connect:
+/- 25 V
com
+
-
If you wanted to use the output for (-25)-0 Volts you would simply connect:
+/- 25 V
com
+
-
So essentially you have 3 ways of generating output power.
With the outputs connected to circuit you can now proceed to power your circuit. Simply
press the Output On/Off button and adjust voltage accordingly. If for any reason during
operation the readings for voltage and current disappear while the output is on, you can
press the Display Limit button to bring the values back up. If you wish to adjust current
you press the Voltage/Current key when you have selected the appropriate voltage mode.
You can then use the left/right arrows to select the digit you would like to change and use
the circular knob to change the actual value.
Rev 02
RED Positive Post = Positive Cable
Black Com Post = Negative/Ground Cable
RED Negative Post = Positive Cable
Black Com Post = Negative/Ground Cable
3/3
17 Jan 2006
Advertisement
