ICP DAS USA VPD-173X Quick Start Manual page 3

4
First Use of the VPD-173X
GND
2. Supply power to the VPD-173X/173X-64, wait
for several seconds and then you can see the
default program run on it.
3. Try to touch on the icons on the bottom-right
corner of the screen of the VPD-173X/173X-64
and you can find that VPD-173X/173X-64
switches to the setting pages.
5
Creating First Project
To create your first project of the VPD-173X/173X-64, install the free development tool,
HMIWorks and then refer to <<TouchPAD_programming_quide.pdf>>, which can be found on
the FTP: http://ftp.icpdas.com/pub/cd/touchpad/document/english/programming_guide/
VPD-173X/173X-64 Quick Start, version 1.0
Copyright © 2018 ICP DAS Co., Ltd.
PoE Switch
VDC (+12~+48V)
External Power
1. Connect wires as the figure. External Power
can be removed if you have a PoE Switch providing
power through an Ethernet cable to the TouchPAD.
And set the rotary switch to zero (At this point, the
power is not yet supplied).
Use a flat-head screwdriver to
set rotary switch
Last Revised: Jun. 2018
All Rights Reserved.
- 3 -
 E-mail: service@icpdas.com