Download Print this page

Amada FBD III-3512 Operator's Manual

Download this manual

FBD III - 3512~1253 (NC9-FS)

OPERATOR'S MANUAL

14921 East Northam Street, La Mirada, CA 90638

any means, electronic, mechanical, photocopying, recording, or otherwise, without written permission from

the publisher. No patent liability is assumed with respect to the use of the information contained herein.

While every precaution has been taken in the preparation of this book, the publisher assumes no

responsibility for errors or omissions. Neither is any liability assumed for damages resulting from the use

of the information contained herein.

Need help?

Do you have a question about the FBD III-3512 and is the answer not in the manual?

Page 1 FBD III - 3512~1253 (NC9-FS) OPERATOR'S MANUAL Copyright © 1998 by Amada Engineering & Service Co., Inc. 14921 East Northam Street, La Mirada, CA 90638 All rights reserved. No part of this book shall be reproduced, stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without written permission from the publisher.
Page 2 Operator’s Manual : FBDIII-3512 - 1253(NC9-FS) 1995 by LTD. No part of this publication may be photocopied or otherwise reproduced without the prior written permission of AMADA CO.,LTD. Printed in Japan...
Page 3 Put the foot pedal alongside the electrical enclosure when it is not used..
Page 5 Set the stroke of the lower beam at less than 8 mm (0.3’) to prevent the insertion of fingers between punches and dies.
Page 7 When 2V dies are used, use the V-groove on the rear side of the machine for additional safety. When work must be bent at tin acute angle, punches may bite into dies and they may be dislodged and fall from the machine.

Fbd iii-5012Fbd iii-8025Fbd iii-1253