Block And Allow Lists; Security Management - Paramont InVid Tech PAR 4MP Series User Manual

Network Camera User Manual
An administrator user can kick out all the other users (including other administrators).

4.6.3 Block and Allow Lists

Go to ConfigSecurityBlock and Allow Lists as shown below.
The setup steps are as follows:
Check the "Enable address filtering" check box.
Select "Block/Allow the following address", IPv4/IPv6/MAC and then enter IP address or
MAC address in the address box and click the "Add" button.

4.6.4 Security Management

Go to ConfigSecuritySecurity Management as shown below.
In order to prevent against malicious password unlocking, "locking once illegal login"
function can be enabled here. If this function is enabled, login failure after trying six times
will make the login interface locked. The camera can be logged in again after a half hour or
after the camera reboots.

Password Security
Please set the password level and expiration time as needed.
Password Level: Weak, Medium or Strong.
Weak level: Numbers, special characters, upper or lower case letters can be used. You can
50