Paramont InVid Tech PAR 4MP Series User Manual page 30

Network Camera User Manual
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
 SD Card Error
When there are some errors in writing SD card, the corresponding alarms will be triggered.

1. Go to Config Alarm
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same
as motion detection. Please refer to
 IP Address Conflict
This function is only available for the models with Alarm Out interface.

1. Go to Config Alarm
 
Anomaly SD Card Error as shown below.
motion detection
 
Anomaly IP Address Collision as shown below.
chapter for details.
23