Table of Contents
Advertisement
Chapter 3:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain setup,
please read the warning below before installation
procedures.
WARNING:
To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from
the server. The power switch button does not
completely shut off system power. Portions of
the power supply and some internal circuitry
might remain active until power is removed.
1.
Unpower the LVC-2000 and remove the power cord.
2.
Remove 4 threaded screws from the bottom to take
off the bottom cover.
3.
Open the cover.
Disk Drive Installation
The system can accommodate one Serial-ATA 2.5" HDD/
SSD. Follow these steps to install a disk drive into the
system:
1.
Take out the hard disk tray and place the disk drive on
the tray with 4 mounting screws as illustrated in the
following picture.
2.
Plug the Serial-ATA cable to the hard disk.
3.
Attach the disk drive to the system's chassis and
secure it with the mounting screws.
4.
Connect the Serial-ATA power and data disk cables to
the Serial-ATA power and disk connectors on the main
board respectively.
1
2
3
4
Advertisement
Table of Contents
