Chapter 4: Hardware Setup - Lanner LEC-7233 Series User Manual

Chapter 4: Hardware Setup
Accessing the Inside of LEC‐7233
To access some components and perform certain service procedures, you must perform the following
procedures first.
WARNING:
To reduce the risk of personal injury, electric shock, or damage to the equipment, please remove all
power sources.
Please wear ESD protected gloves before conducting the following steps.
Do NOT pile items on top of the system to prevent damages due to this improper use. Lanner is not
liable for damages caused by improper use of the product.
1. Power off LEC‐7233 and remove the power cord.
2. Remove the screws from all sides and the rear, as circled in the image below. Please also remove the
four rubber pads as well. It is recommended to use screwdriver sized 3 for these M3 dimension nails.
Embedded Computing Platform
23