Table of Contents
Advertisement
Image Stabilizer
The Image Stabilizer cannot compensate for a
O
O
blurred shot caused by a subject that moved.
The Image Stabilizer might not be fully effective
O
O
in the following conditions:
• Large shake or fast vibration
• Panning in MODE 1
If using a camera that allows you to change
O
O
the shutter mode setting, [Elec. 1st-curtain] or
[Electronic] settings is recommended* to allow
the Image Stabilizer to be fully effective.
* When using an EOS R camera, select either
[Mode 1] (default factory setting) or [Mode
2] in the [Silent LV shoot.] settings, or select
[Enable] in the [Silent shutter] settings.
Setting the STABILIZER switch to ON consumes
O
O
more power than when OFF.
Vibration such as during transport may unlock
O
O
the Image Stabilizer and cause rattling, but this
is not breakage and will have no effect on usage.
This will be rectified once the lens has been
mounted on the camera.
When using a tripod, it is recommended that you
O
O
set the image stabilizer switch to OFF.
Although image stabilization will operate when
O
O
using a monopod, depending on the shooting
conditions, sometimes the Image Stabilizer might
not be fully effective.
Depending on the camera there may be image
O
O
shake, such as after releasing the shutter.
However, this does not affect shooting.
If you set the camera's Custom Function to
O
O
change the AF button assignment, the Image
Stabilizer will operate when you press the newly
assigned AF button.
ENG-19
Advertisement
Table of Contents
