Download Print this page

Really Good Stuff 159790 Assembly Instructions

Classroom mail center

Advertisement

Quick Links

Really Good Classroom Mail Center
Assembly Instructions:
Congratulations on your purchase of this Mail Center.
Before you begin, please refer to the Parts List to ensure that all materials needed for
assembly have been received. You may also need a Phillips Screwdriver.
Helpful Hints:
• Check the direction of the arrows on each locking cam during assembly. All arrows must
point toward the small holes located on the outer edge of the panels before tightening.
• All studs must be screwed in approximately 1/2" until the shoulder meets the surface.
To screw in studs use the assembly tool supplied or a straight or Phillips screwdriver.
Parts List:
(Assembly Tool included)
Item
Description
A
Top Panel
B
Bottom Panel
C
Left Side Panel
D
Right Side Panel
E
Center Dividers
F
Shelves
G
Back Center Panel
H
Back Side Panels
N/A
Sheet of 30 Labels
N/A
Bag of Hardware
STEP ONE
Locate bottom panel B. Push in four small cam locks into the
four holes on the bottom side of this panel. Turn the panel over
and screw four studs into the four plastic threaded plugs.
Push four wooden pegs into the remaining four holes.
STEP TWO
Locate the two center dividers E (they have slots on both sides
for the shelves). Push four large cam locks into the four holes.
Stand the bottom panel B on edge lengthwise. Take one center
divider also on edge and push one end down over the wooden pegs
and studs, matching the finished edges. Turn the cam locks until
they are tight. The second divider E should be installed the same
way.
STEP THREE
Locate the left side panel C. The side of the panel with the slots
should face in and the end with the finished edge is the bottom.
Screw in two studs and push two wood pegs in the holes near
the bottom on the side with the slots. The studs and pegs on
the side panel should be pushed in the holes in the ends of the
bottom panel. Turn the cam locks on the bottom of the bottom
panel until tight. Do this to both sides. Install two cam locks on
each side panel at the top. Repeat with the other side panel D.
STEP FOUR
Insert four small cam locks into the top of panels C & D, and four
large cam locks into top the of panel E.
Helping Teachers Make A Difference
Qty.
1
1
1
1
2
24
1
2
1
You may also have received one spare part of each piece of hardware.
1
© 2011 Really Good Stuff
®
1
Bottom Panel B
2
Bottom Panel B
3
Bottom
Panel B
Left Side Panel C
®
1-800-366-1920 www.reallygoodstuff.com Made in Dongguan, China #159790
Center Divider E
Bottom Panel B

Advertisement

loading

Summary of Contents for Really Good Stuff 159790

  • Page 1 Insert four small cam locks into the top of panels C & D, and four large cam locks into top the of panel E. Bottom Panel B Left Side Panel C Helping Teachers Make A Difference © 2011 Really Good Stuff ® 1-800-366-1920 www.reallygoodstuff.com Made in Dongguan, China #159790 ®...
  • Page 2 Back Side Panel H adhesive. Fold label in half and adhere label to the underside of the shelf with writing facing outward. Helping Teachers Make A Difference © 2011 Really Good Stuff ® 1-800-366-1920 www.reallygoodstuff.com Made in Dongguan, China #159790 ®...