Really Good Stuff 158589 Assembly Instructions

Really Good Classroom Library Rack Assembly Instructions
Congratulations on your purchase of this Really Good Classroom Library Rack.
This Really Good Stuff
®
product includes:
A1 – Right outside frame
A2 – Left outside frame
B1 – Horizontal bar with holes in
the middle
B2 – Rear horizontal bar
B3 – Front top horizontal bar
B4 – Front bottom horizontal bar
C1 – Right stabilizer arm
C2 – Left stabilizer arm
D – 8 Large screws
E – 8 Curved plastic washers
F – 4 Small screws
G – 4 Rubber feet
H – 4 Locking wheels
I – 1 Allen wrench
To assemble this Really Good Classroom Library Rack:
1. Attach the horizontal bar B1, to the top rear of both
outside frames A1 and A2 using large screws D and
curved plastic washers E. The flat side of the plastic
washer should go against the horizontal bar. The 2
holes on horizontal bar must face down.
2. Attach the remaining three horizontal bars B2, B3,
B4, leaving the screws loose
for the stabilizer bar assembly.
3. Be sure that the top rear
horizontal bar screw holes
face downward.
4. Screw the top of the stabilizer
arm C2 to the underside hole
on the top rear horizontal bar B1 using a small screw F.
2
Helping Teachers Make A Difference
A2
C2
B1
B2
B3
B4
®
© 2011 Really Good Stuff
D
A1
C1
1
Rack Front
face down.
A2
Rack Rear
NOTE:
• Each outside frame A1, A2 has a screw hole in the bottom of one
leg. This hole denotes the rear side of the rack.
• Only one of the horizontal bars B1 has two screw holes in the
center to attach the stabilizer arms.
3
Rear
1-800-366-1920 www.reallygoodstuff.com Made in Guangzhou, China #158589
®
G
H
E
F
I
A1
2 holes
B1
This screw hole in bottom
of leg denotes the rear
side of the rack. It must
face inward as shown.
A1
A2
B1
B3
B4
B2
All instructional guides can be found online:
Front