Really Good Stuff Really Good Book Exhibit Stand Instructional Manual

Really Good Book Exhibit Stand
Congratulations on your purchase of this Really Good Book Exhibit Stand
Adult assembly required.
Note: Phillips head screwdriver may be helpful for assembly.
This Really Good Stuff
product includes:
1 Magnetic strip
1 Front wire frame
1 Back wire frame
1 Wire stand
4 Hooks
4 Nuts and bolts
To assemble this Really Good Book Exhibit Stand
1. Attach the wire stand to back wire frame by
inserting the 2 open ends of the stand into the
circular washer holes located on each side of the
back wire frame. You will have to use a little force.
2. Insert 2 hooks into the top of the corresponding
hex nut holes located on each side of the wire
frame. Stand frame up to line the holes in the
hooks up with corresponding holes in back wire
frame.
Note: Hooks are side specific. Each hook has a flat
side that will face outward. The indented side will
face in and touch the wire frame when secured to
it with a nut and bolt.
3. Secure hooks to the back wire frame using 1 nut
and 1 bolt per hook. Place the bolt into the hole in
the hook and through the hole in the frame. Hand
tighten the nut onto the bolt.
Rev.3 07/19
Helping Teachers Make A Difference

Parts

®
Hooks
Magnetic
strip
Bolts Nuts
™
®

Assembly Instructions

™
.
™
Front wire frame Back wire frame
:
1
2
© 2010 Really Good Stuff 1-800-366-1920 reallygoodstuff.com Made in China #158414
®
Wire stand
3