Table of Contents
Advertisement
Problem
The hob deactivates.
Residual heat indicator does
not come on.
Hob²Hood function does not
work.
Automatic Heat Up function
does not operate.
You cannot activate the out‐
er ring.
There is a dark area
on the multiple zone.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on.
Possible cause
You put something on the
sensor field
.
The zone is not hot because
it operated only for a short
time.
You covered the control pan‐
el.
The zone is hot.
The highest heat setting is
set.
It is normal that there is a
dark area on the multiple
zone.
Power management function
operates.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper‐
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
ENGLISH
Remedy
Remove the object from the
sensor field.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Let the zone become suffi‐
ciently cool.
The highest heat setting has
the same power as the func‐
tion.
Activate the inner ring first.
Refer to "Daily use" chapter.
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and acti‐
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If
comes on again, speak
to an Authorised Service
Centre.
17
Advertisement
Table of Contents
