The 715 consists of two main parts, a cable reel and an IR sensor. The cable reel houses the detector electronics and battery and is also used to store the sensor cable when not in use. The 715 is supplied with either an IR8, IR15, IR40 or IR100 sensor as required for the application.
715 Portable – Instruction Manual Operation The 715 is ready for operation once the power switch is moved to the ON position. Before using the 715 to determine the sludge interface position, it is worthwhile performing the operation test below.
• Application details • Description of fault • Returning Equipment for Repair If equipment needs to be returned to Partech for repair or service the following address should be used: SERVICE DEPARTMENT PARTECH INSTRUMENTS ROCKHILL BUSINESS PARK HIGHER BUGLE ST AUSTELL...
Height (mm) Depth (mm) * The maximum supernatant value is the point at which the 715 will not detect sludge. ** The minimum sludge value is the starting point for detection of sludge. Note: The values quoted are based on the typical solids found on a municipal sewage treatment works.