Pre-Installation; Mounting The Anti-Tip Brackets - Forte 450 Series Installation Manual

PRE-INSTALLATION

Continue to install the product according to the instructions below. Additionally, consider national and local
instructions regarding installation.
Please observe the following:
•
For the USA, The National Electrical Code, ANSI/NFPA 70 – last version/State or Municipality
directives and/or regional directives.
•
For Canada, The Canadian Electrical Code, C22.1 – last version/State or Municipality directives
and/or regional directives.

Mounting the Anti-Tip Brackets

WARNING:
You must definitely use Anti-Tip Brackets to prevent the appliance from tipping over.
WARNING:
Make sure that there is no electrical or water connection where the screws will be tighten and connections will be
established.
WARNING:
Please remember to use the necessary protective equipment when drilling holes on the wall and performing
installation.
•
Mark the wall for Anti-Tip Brackets (7).
Category
A
B
C
B
C
Anti tip brackets on the wall
A
F16BFRESC450PR
30" (762mm)
23 5/8" (600mm)
3 3/16" (81mm)
34
C
F20BFRESC450PR FFD20ESC450PR
36" (914mm) 36" (914mm)
23 5/8" (600mm) 23 5/8" (600mm)
6 3/16" (157mm) 6 3/16" (157mm)