Electrolux EDP2074PMW User Manual page 4

4 www.electrolux.com
appliance specified in the instructions, supplied with
the accessory. Read it carefully before installation
(Refer to the Installation leaflet).
The appliance can be installed as freestanding or
•
below the kitchen counter with correct space (Refer to
the Installation leaflet).
Do not install the appliance behind a lockable door, a
•
sliding door or a door with a hinge on the opposite
side, that would prevent the appliance door from being
fully opened.
The ventilation opening in the base must not be
•
covered by a carpet, mat, or any floor covering.
WARNING: The appliance must not be supplied
•
through an external switching device, such as timer, or
connected to a circuit that is regularly switched on and
off by a utility.
Connect the mains plug to the mains socket only at
•
the end of the installation process. Make sure that the
mains plug is accessible after installation.
Ensure good air ventilation in the located room to
•
avoid the backflow of unwanted gases into the room
from appliances burning gas or other fuels, including
open fires.
If the mains power supply cable is damaged, it must
•
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Do not exceed the maximum load of 7 kg (refer to the
•
"Programme chart" chapter).
Do not use the appliance if items have been soiled
•
with industrial chemicals.
Wipe away lint or packaging debris that has
•
accumulated around the appliance.
Do not run the appliance without a filter. Clean the lint
•
filter before or after each use.
Do not dry unwashed items in the tumble dryer.
•