Related Manuals for SYSFORM 310M
Summary of Contents for SYSFORM 310M
- Page 1 310M Paper Cutter Operation Manual ※Please read this manual carefully before operating the machine. Revision: 27/04/21...
- Page 3 Table of Contents 1. Safety & Warning..............1.1 Safety Rules............... 1.2 Precautions..............1.3 Do’s And Don’ts............1.4 Safe Transport............2. Unboxing................3. Installation................4. Description of Parts............. 5. Operation................6. Maintenance - for trained staff only!......... 6.1 Blade Replacement..........6.2 Cutting Stick Replacement......... 7.
- Page 4 1. Safety & Warning 1.1 Safety Rules The machine has blade lock which make it a safe to operate. Regardless of your experience, safety instructions must be read carefully, completely understood, and applied to your daily work habits. If you do not understand or are confused by certain safety instructions presented in this manual, discuss them with your supervisor.
- Page 5 1. Safety & Warning (Continued) 1.4 Safe Transport 1.4.1 For a short transport (few meters): Though this is a small machine, we suggest that two persons lift up the machine together carefully and move it to another place. 1.4.2 For more than a few meters: The machine should be packed again in the orginal packaging.
- Page 6 5. Operation Switch on 5 Cutting line switch. The cutting line appears. Adjust 6 Backgauge to the required position. Put the paper sheet in the machine. Align the paper against the backgauge and 7 Side lay. Push 2 Blade lock and press 1 Handle down to cut the paper sheet. Rlease the handle and make sure it is locked by the blade lock.
- Page 7 6. Maintenance (Continued) 6.1 Blade Replacement - continued Warning: do not reach beneath the blade and clamp! 6.1.7 Take off the blade cover from 6.1.8 Use both hands to insert the new the new blade. blade into the machine carefully. Caution: Sharp blade! 6.1.9 Cover the old blade with the blade cover carefully.
Need help?
Do you have a question about the 310M and is the answer not in the manual?
Questions and answers