Table of Contents
Advertisement
ADCP-80-421 • Issue 1 • October 2001
Connect the opposite ends of the wires to the input connectors of the alarm unit. Refer to the
installation manual of the alarm unit for wiring connections.
After installing Power Supply Card connect alarm male connector to female connector on
chassis rear as shown in
2.1.5
Blank Panels
If applicable, remove blank panels by loosening fastener screws and pulling out from chassis as
shown in
Figure 11
Page 8
© 2001, ADC Telecommunications, Inc.
Figure
10.
Figure 10. Alarm Connector, Male-to-Female Connection
and
Figure
12.
Figure 11. Removing Blank Front Panels
16875-A
16855-A
Advertisement
Table of Contents
