Installing The Em50; Downloading Data; Turning Off The Em50 - Decagon Devices Em50 Quick Start Manual

Make any other desired configuration settings, then click "Apply."
10.
11.
When first setting up the Em50, erase the memory. This ensures a clean data
set before taking measurements.
12. Log off the Em50 by clicking the Disconnect icon.
13. Exit DataTrac 3 or ECH

Installing the Em50

1. Attach the Em50 in an upright position to a firm post or PVC pipe, using
the five zip ties or similar fasteners.
2. If using the Em50R , ensure there is a good line of sight between the logger
and your base station. Radio signal strength can be attenuated by obstruc-
tions.
3. If using the Em50 Solar data logger, install the logger in a location that
ensures the solar panel receives the maximum amount of sunlight. In the
northern hemisphere this typically means the data logger should face South.
In the southern hemisphere this typically means that the data logger should
face North.

Downloading Data

2.
Start DataTrac 3 or ECH2O Utility
3.

Turning Off the Em50

To turn off the Em50, either set the measurment interval to "0 minutes" or remove
the batteries.
For more detailed information, see the Em50 series User's Manual.
©2015 Decagon Devices, Inc
10782 | 02-10-15
O Utility.
2
2365 NE Hopkins Court
Pullman, Washington 99163
tel: 509-322-2756
support@decagon.com