HP LSI MegaRAID SAS 9260-8i Installation Manual page 6

RAID controller card features
Each internal connector, labelled (1) and (2), supports up to four SAS hard drives.
The hard drive activity LED is connector (3).
Figure 3
Table 2 Port connectors
Connector
(1)
(2)
(3)
Card BIOS default settings:
See Step 6—Configuring RAID devices on page 11
●
card BIOS defaults.
Blind-mate data cable connections
NOTE:
This procedure assumes that the primary hard drive is located in HDD-BAY-0, and that all
internal bays are being connected to the RAID controller.
• It is not necessary to connect all internal drives or use all four of the connectors on the MiniSAS
internal adapter cable.
• The short MiniSAS 4i-4X SATA cable is used only to connect SAS hard drives located in the internal
hard drive bays of HP Z Workstations with blind-mate cabling.
• A long MiniSASi data cable is used to connect SAS hard drives located in the optical drive bays. See
Standard data cable connections on page
6 LSI MegaRAID SAS 9260-8i card installation
Identifying the SAS controller ports
Description
Internal connector 1 (SFF-8087 MiniSAS labelled JT6)
Internal connector 2 (SFF-8087 MiniSAS labelled JT7)
Hard drive LED connector (2-pin connector labelled JT2)
for information about setting and resetting
8.
ENWW