Mark Levinson N 326S Owner's Manual page 13

Nº326S Preamplifier
Placement
Item
Detachable AC power cord
Link communication cable
1/8-inch hex key
Phillips-head screwdriver (size 1)
Nº326S remote control *
White gloves (pair)**
Warranty & Product Registration Card
* The remote control comes with two AAA batteries, which
should be replaced as needed.
** The white gloves are provided to assist with the initial unpacking
and installation of the Nº326S.
DO
• install the Nº326S on a solid, flat, level surface such as a
shelf or table.
DO
• install the Nº326S close to associated components to keep
interconnect cabling as short as possible.
Note
In some cases, it is better to use longer interconnect cabling
between the preamplifier and the power amplifier to allow
for shorter loudspeaker wires.
DO
• select a dry, well-ventilated location out of direct sunlight.
DO
• allow at least a 4-inch clearance above the Nº326S for
proper heat dissipation. It is strongly recommended to install
the Nº326S on its own shelf for proper ventilation.
DO
• refer to Dimensions (page A-3) for assistance with custom
installations.
DO NOT
• place the Nº326S on a thick rug or carpet or cover
the Nº326S with a cloth, as this might prevent proper cooling.
DO NOT
• expose the Nº326S to high temperatures, humidity,
steam, smoke, dampness, or excessive dust. Avoid installing
the Nº326S near radiators and other heat-producing appliances.
Getting Started
Quantity
1
1
1
1
1
1
1
1-5