Home Connect; Setting Up Home Connect; Installing Updates For The Home Connect Software - Siemens GIN81H Series Information For Use

en Home Connect
a From this time on, the warmest
temperature is measured again
and saved.
lights up until the set temper-
a
ature is reached again.
Home Connect
10 Home Connect
This appliance is network-capable.
Home Connect
Connect your appliance to a mobile
device to control its functions via the
Home Connect app.
The Home Connect services are not
available in every country. The avail-
ability of the Home Connect function
depends on the availability of
Home Connect services in your coun-
try. You can find information about
this at: www.home-connect.com.
To be able to use Home Connect,
you must first set up the connection
to the WLAN home network (Wi-Fi
and to the Home Connect app.
After switching on the appliance, wait
at least 2 minutes until internal
device initialisation is complete. Only
then should you set up Home Con-
nect.
The Home Connect app guides you
through the entire login process. Fol-
low the instructions in the Home Con-
nect app to configure the settings.
Tips
¡ Please consult the documents sup-
plied by Home Connect.
¡ Please also follow the instructions
in the Home Connect app.
Notes
¡ Please note the safety precautions
in this instruction manual and
make sure that they are also ob-
1
Wi-Fi is a registered trademark of the Wi-Fi Alliance.
16
served when operating the appli-
ance via the Home Connect app.
→ "Safety", Page 6
¡ Operating the appliance on the ap-
pliance itself always takes priority.
During this time it is not possible
to operate the appliance using the
Home Connect app.
10.1 Setting up Home Con-
nect
Requirement: The Home Con-
nect app has been installed on your
mobile device.
Scan the QR code using the
1.
Home Connect app.
1
)
Follow the instructions in the
2.
Home Connect app.
10.2 Installing updates for the
Home Connect software
The appliance searches for updates
to the Home Connect software at reg-
ular intervals.
Note: If updates are available, the
temperature display shows
To reset the update and the temper-
ature display to the set temperature,
press any touch field.
Press
1.
a The temperature display shows
.
.
.