Table of Contents
Advertisement
S2 (A-11): RESET (Tactile switch)
This is the hardware reset switch of the CPU-94 board.
Press the RESET switch of the CPU board on which the indicator D15 (ACTIVE) lights in order to change the operation
from the main CPU-94 board to the backup CPU-94 board.
S3 (A-12): NMI (Tactile switch)
This is a test switch. Press this switch to enter the monitor mode. The normal operation is interrupted.
Press the switch S2 (RESET) to return to normal operation.
S4 (G-2): SW LINE SELECT (Rotary switch HEX)
This switch sets the switching position of the crosspoint.
For the details, refer to "Switching Point Depending upon S4 Setting" on next page.
Factory setting: 1
S5 (A-1): STATION ADR (DIP switch)
This switch sets the station address of this unit on the S-BUS link.
The factory setting is shown as follows. (The
Factory setting: All ON
ON
1
2
3
4
5
6
S6 (A-2): Not used (DIP switch)
Factory setting: All ON
S7 (A-5): TEST (Rotary switch HEX)
This switch is used to change a mode of the test.
Set the switch to 0 usually.
Refer to "3. Maintenance Mode" for the details.
Factory setting: 0
S8 (D-3): (DIP switch)
This switch selects the modes. The factory setting is shown as follows. (The
ON
1
2
3
4
5
6
• S8-1 to 4 : Not used
• S8-5 : Model name setting
When a backup CPU-94 board is installed, it is necessary to input "BVS-A3232" as a supported model into the board.
Set the switch to ON to enter the mode to input the model name. Set the switch to OFF for normal operation.
Refer to "1-7-2. Initial Setting of Backup CPU-94 Board" for the details.
Factory setting : OFF
• S8-6 and 7 : Not used
• S8-8 : ISR mode
This switch selects ISR mode (ON) or a terminal mode (OFF).
Refer to Section 2-12 for the details of ISR mode.
Factory setting : OFF
BVS-A3232
mark indicates the switch lever position.)
7
8
7
8
1-12. Settings of Switches and Controls/LED Functions on Board
mark indicates the switch lever position.)
1-13(E)
Advertisement
Table of Contents
