Advertisement
5.2 Oven:
1.
Before using, please clean the device completely, especially the oven chamber.
Remove all the packing materials and film. Before cleaning the stainless steel
accessories, please make sure that the used detergent contains no corrosive
substance and suits to the stainless steel surface cleaning. Then dry the device with
clean cloth.
2.
When first using, it is normal that there is unpleasant smell. (Make sure that the smell
is not caused by gas leakage.) In fact, that is produced by overheating of the
insulating material and oil residue during heating process of the metal. If the oven is
used at the first time, do not put any food into the chamber, set the temperature to
320℃ and heat till the smell is gone.
3.
When first using, the duration of ignition may be a little longer due to the air existing in
the new pipe. It cannot be ignited until all the air is exhausted.
4.
Responding temperature of the chamber center on the oven knob: 100℃, 150℃,
5.
During ignition, please open the lid under the door downward, press down the knob
200℃, 250℃, 320℃
and rotate it anticlockwise to "
the pilot flame with lighter via the ignition hole.
6.
After the pilot flame is ignited, press the knob for more than 20 seconds to heat up the
thermocouple. If the ignition is out when you loosen the knob, repeat this operation.
7.
Keep rotating the temperature control knob anticlockwise to ignite the main burner of
the oven. Select appropriate temperature according to food requirement. The oven
temperature can be controlled between 100℃ and 320℃.
8.
To turn off the burner: Rotate the knob clockwise to strip mark and align with the
salient point.
Note: If the gas type needs to be changed from NG to LPG, the nozzles of main burner
and pilot flame should be replaced.
6. Routine Inspection
It is necessary to check the machine daily.
Check the machine regularly can avoid serious accident happens.
Stop using if user feels that there are some problems in the circuit or machine.
Check the situation of the machine before or after using every day.
Before using: Whether the machine is tilted?
Whether the control panel is damaged?
During using: Whether there is strange smell or vibration noise?
Whether the flame of burner is normal? Any light back or flameout?
Whether the power is normal?
", align with the salient point and press down. Ignite
11
Advertisement
