Supplied Accessories; Attaching The Stand - Magnavox 32MD350B User Manual

I
NTRODUCTION
5 Supplied5Accessories 5
user manual
(1EMN25919A)
• If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.
Note:
• For 32MD350B, nonremovable AC power cord is already fixed on the unit.
5 Attaching5the5Stand 5
You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper direction.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least 2 people are required at this
step.
To remove the stand from this unit
Unscrew the Phillips pan screws on step 3.
After the screws are removed pull the stand up toward the rear of the unit. Be careful not to drop the stand when you remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.
6
EN
quick start guide remote control
For 37MD350B
(NF801UD)
(1EMN25960)
For 32MD350B
(1EMN25920)
2
Align the 2 stand hooks with the two
hooks under the bottom of the main
unit (shown by arrow
the stand in the direction as shown
by arrow

mounting holes are aligned.
For 32MD350B
Make sure not to put the AC power
cord between the stand and the unit.

registration card
(1EMN24699)
batteries
(AAA, 1.5V x 2)
screw kit for attaching the stand
For 37MD350B 3 screws (1ESA20208)
For 32MD350B 4 screws (1ESA19508)
), then slide
Œ
until it stops and the
Œ
For 37MD350B only
AC power cord
(WAV0162LW001) or
(WAV0162LTE03) or
(WAV152ZHN001)
3
Drive Phillips pan screws in
threaded holes at the bottom of the
stand until they are tight.